Author Topic: 455 starts then dies  (Read 467 times)

0 Members and 26 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23708
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

  • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Re: 455 starts then dies
« on: April 01, 2022, 07:50:25 am »
New carb aftermarket?   They can be hit or miss. 
Carb adjustment setting from get go close to be able to start and run (not all carbs and saws the same)?
Check for impulse blockage. 
Has impulse line been replaced?     
Crank seals etc checked?
Vac and pressure test?
Has piston ring in a blind corner been pinned. Seen that before too.

I hate these style of strato saws with the dang tubes. Just air leaks waiting to happen. Poor design. IMO.



 

 

Related Topics

  Subject / Started by Replies Last post
13 Replies
1658 Views
Last post March 09, 2012, 01:51:34 pm
by eli-dream
17 Replies
2036 Views
Last post February 12, 2013, 07:48:58 am
by bassman
9 Replies
1482 Views
Last post October 26, 2013, 10:25:33 pm
by 660magnum
21 Replies
1678 Views
Last post April 11, 2014, 08:58:12 pm
by 3000 FPS
16 Replies
1161 Views
Last post December 27, 2013, 05:37:28 am
by 660magnum
7 Replies
1004 Views
Last post October 29, 2014, 03:58:59 pm
by Fish
16 Replies
1789 Views
Last post October 25, 2015, 09:19:53 pm
by mikehonda
4 Replies
526 Views
Last post March 30, 2018, 10:35:37 am
by joel4bs
2 Replies
771 Views
Last post July 04, 2018, 08:14:36 am
by Cut4fun .
3 Replies
417 Views
Last post September 12, 2018, 03:41:52 pm
by bsaumph