Author Topic: 455 x-torq first one  (Read 185 times)

0 Members and 0 Guests are viewing this topic.

Offline dannyupsolate

  • Piped Saw
  • *****
  • Posts: 328
  • Karma: 28
455 x-torq first one
« on: August 21, 2016, 08:44:42 pm »
just took in my first 455xtork .bar plate was chewed up exterior of oiler full of chips and goo. got it clean any other common problems in well used 455.

Share on Facebook Share on Twitter


Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 21880
  • Karma: 522
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: 455 x-torq first one
« Reply #1 on: August 22, 2016, 11:00:39 am »
I take care of a husqvarna 455 for a firewood cutter.   If my memory is right. Depending on when made there was a update to the bar oil tank filter. The early one was to coarse and allowed fines in to plug up line and pump. 
Also had 200T do this too.

Check the thread 455 here on it. I also had the worm gear strip and melt to the crankshaft.
REDNECK Saw Repair Getter Done

Offline dannyupsolate

  • Piped Saw
  • *****
  • Posts: 328
  • Karma: 28
Re: 455 x-torq first one
« Reply #2 on: August 22, 2016, 01:46:46 pm »
we figured it out . beat up bar plate kept rubber part from spinning oil pump. tested it without bar plate and chain and it oiled.  bar plate pushed on top of rubber held it stationary.
Like Like x 1 View List

 

Related Topics

  Subject / Started by Replies Last post
10 Replies
2450 Views
Last post May 03, 2011, 09:49:54 pm
by blsnelling
127 Replies
13005 Views
Last post December 26, 2012, 10:16:57 am
by Cut4fun
0 Replies
614 Views
Last post July 22, 2012, 07:34:54 pm
by 660magnum
2 Replies
561 Views
Last post July 23, 2012, 07:49:15 am
by 660magnum
19 Replies
775 Views
Last post November 10, 2013, 08:11:53 pm
by KilliansRedLeo
6 Replies
305 Views
Last post June 09, 2014, 08:05:24 pm
by Cut4fun .
21 Replies
558 Views
Last post November 29, 2014, 08:29:17 am
by weimedog
7 Replies
208 Views
Last post February 28, 2016, 07:32:00 pm
by 660magnum
2 Replies
91 Views
Last post May 07, 2018, 02:36:08 pm
by Cut4fun .
4 Replies
128 Views
Last post July 12, 2018, 09:03:40 am
by ray benson