Author Topic: 455 x-torq first one  (Read 385 times)

0 Members and 1 Guest are viewing this topic.

Offline dannyupsolate

  • Piped Saw
  • *****
  • Posts: 328
  • Karma: 28

  • Total Badges: 18
    Badges: (View All)
    Third year Anniversary Karma Good Level 4 Second year Anniversary Poll Voter One year Anniversary
455 x-torq first one
« on: August 21, 2016, 08:44:42 pm »
just took in my first 455xtork .bar plate was chewed up exterior of oiler full of chips and goo. got it clean any other common problems in well used 455.

Share on Facebook Share on Twitter


Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23706
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

  • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Re: 455 x-torq first one
« Reply #1 on: August 22, 2016, 11:00:39 am »
I take care of a husqvarna 455 for a firewood cutter.   If my memory is right. Depending on when made there was a update to the bar oil tank filter. The early one was to coarse and allowed fines in to plug up line and pump. 
Also had 200T do this too.

Check the thread 455 here on it. I also had the worm gear strip and melt to the crankshaft.

Offline dannyupsolate

  • Piped Saw
  • *****
  • Posts: 328
  • Karma: 28

  • Total Badges: 18
    Badges: (View All)
    Third year Anniversary Karma Good Level 4 Second year Anniversary Poll Voter One year Anniversary
Re: 455 x-torq first one
« Reply #2 on: August 22, 2016, 01:46:46 pm »
we figured it out . beat up bar plate kept rubber part from spinning oil pump. tested it without bar plate and chain and it oiled.  bar plate pushed on top of rubber held it stationary.
Like Like x 1 View List

 

Related Topics

  Subject / Started by Replies Last post
2 Replies
876 Views
Last post April 13, 2011, 04:26:56 pm
by Iron City
10 Replies
3117 Views
Last post May 03, 2011, 09:49:54 pm
by blsnelling
127 Replies
15880 Views
Last post December 26, 2012, 10:16:57 am
by Cut4fun
0 Replies
1193 Views
Last post July 22, 2012, 07:34:54 pm
by 660magnum
2 Replies
1012 Views
Last post July 23, 2012, 07:49:15 am
by 660magnum
0 Replies
280 Views
Last post March 03, 2013, 08:14:40 pm
by Cut4fun
19 Replies
1528 Views
Last post November 10, 2013, 08:11:53 pm
by KilliansRedLeo
2 Replies
387 Views
Last post May 07, 2018, 02:36:08 pm
by Cut4fun .
4 Replies
528 Views
Last post July 12, 2018, 09:03:40 am
by ray benson
12 Replies
643 Views
Last post October 19, 2022, 08:30:49 pm
by EHP