Author Topic: Husqvarna 50  (Read 8305 times)

0 Members and 24 Guests are viewing this topic.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

  • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Husqvarna 50
« Reply #100 on: May 05, 2020, 11:37:44 am »
I found a cylinder made for the Husqvarna 50, 51 with a 45mm bore.   I checked it last night and it is a proper fit.   So a little modifying to the cylinder and then will start to put it together.    I also have new crank seals and will replace them too.    The intake area looked ok and the impulse looked ok.   But it sure was run lean and was scored pretty bad.    Maybe it got straight gassed.   
PP 505, 475, 445.
Like Like x 1 View List

 

Related Topics

  Subject / Started by Replies Last post
Husky 266

Started by woodplayer « 1 2 3 4 » Husqvarna

35 Replies
4381 Views
Last post November 23, 2023, 07:45:04 am
by Cut4fun .
Husky 556

Started by Spike60 « 1 2 3 » Husqvarna

29 Replies
2603 Views
Last post September 05, 2014, 07:35:49 pm
by SawTroll
3 Replies
490 Views
Last post June 24, 2013, 08:31:57 pm
by 660magnum
4 Replies
683 Views
Last post July 02, 2013, 09:47:32 pm
by farmboy
husky 55 help

Started by mrbb « 1 2 » Husqvarna

15 Replies
1348 Views
Last post July 29, 2013, 07:59:33 am
by mrbb
1 Replies
312 Views
Last post July 28, 2013, 08:21:22 pm
by Cut4fun .
15 Replies
1325 Views
Last post January 23, 2015, 02:03:24 pm
by Bluegill
1 Replies
423 Views
Last post February 03, 2018, 07:42:16 am
by Cut4fun .
4 Replies
526 Views
Last post March 30, 2018, 10:35:37 am
by joel4bs
2 Replies
554 Views
Last post April 27, 2018, 08:04:59 pm
by leec