Author Topic: Husky #345 oiler output question??  (Read 158 times)

0 Members and 0 Guests are viewing this topic.

Offline Brookside

  • pruner
  • *
  • Posts: 1
  • Karma: 0
Husky #345 oiler output question??
« on: April 26, 2016, 04:16:37 pm »
I have a Husky 345. Not sure if I am getting enough oil output?

Running the saw, I do not see any oil splatter. I removed the bar and chain and
ran the saw and found oil being pumped out of the oil pump, but not sure if it's
enough oil for the chain?

I cut a lot of dead wood and find the chain has a glazed coating and is dry after
cutting for a while.

Should I replace the oil pump? Any advise on a good after market brand to use?

Can I use the adjustable oil pump that is used on the model 350?

Share on Facebook Share on Twitter


Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22117
  • Karma: 550
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Husky #345 oiler output question??
« Reply #1 on: April 26, 2016, 04:33:17 pm »
Is a husky 345 the same as a jred 2145?  http://chainsawrepair.createaforum.com/jonsered/cs-2145/

If it is this thread talks about upgrading the oiler to adjustable.   

Might want to figure out why yours isnt oiling first. Like bar oiler hole or groove plugged up. Etc
REDNECK Saw Repair Getter Done
Like Like x 1 View List

 

Related Topics

  Subject / Started by Replies Last post
11 Replies
534 Views
Last post March 28, 2011, 02:59:09 pm
by totte
1 Replies
183 Views
Last post December 24, 2012, 05:30:19 am
by Al Smith
14 Replies
345 Views
Last post January 26, 2013, 01:38:18 pm
by mdavlee .
6 Replies
208 Views
Last post October 16, 2013, 04:50:13 pm
by Al Smith
066 on a 064 question

Started by SDB777 « 1 2 » Stihl

18 Replies
860 Views
Last post January 29, 2014, 03:10:18 pm
by Tractorsaw1
12 Replies
202 Views
Last post February 28, 2014, 07:02:18 am
by sharkey
16 Replies
344 Views
Last post May 02, 2014, 09:50:35 am
by KilliansRedLeo
3 Replies
122 Views
Last post September 30, 2014, 05:52:33 pm
by mrbb
10 Replies
228 Views
Last post October 18, 2014, 10:29:15 pm
by jmester
1 Replies
216 Views
Last post March 29, 2015, 01:01:09 pm
by Fishnuts2