Author Topic: Can't split the case  (Read 618 times)

0 Members and 0 Guests are viewing this topic.

Offline Al Smith

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2757
  • Karma: 172
Re: Can't split the case
« Reply #40 on: October 09, 2013, 07:39:06 pm »
Sicker cats than that have lived .That one from the picture doesn't look that bad .Even if you break the ring getting it out a generic ring is only 5-6 bucks .

Use a little Scotch brite pad and  kerosine and you should be able to get the tramp aluminum out of the cylinder .Fine sand clothe and kerosine  and sand the piston .A low spot won't  generally hurt you unless its large .A high spot breaks the surface tension of the oil film and will .If the ring groove is screwed up you can use a finger nail file and clean it up .

I've done a lot of half-fast fixes that are still running and running well I might .Contrary to popular belief things don't have to be perfect .Remember you're not building a 16,000 RPM alkie burning piped hot saw .

 

Related Topics

  Subject / Started by Replies Last post
19 Replies
2042 Views
Last post October 27, 2013, 12:28:32 pm
by Cut4fun .
2 Replies
264 Views
Last post November 10, 2012, 12:45:34 pm
by HolmenTree
9 Replies
1901 Views
Last post March 10, 2013, 10:23:17 pm
by 660magnum
14 Replies
936 Views
Last post October 19, 2013, 08:27:09 pm
by Old Iron Logging
20 Replies
510 Views
Last post May 30, 2015, 02:51:07 pm
by Eccentric
8 Replies
174 Views
Last post August 07, 2014, 06:16:36 pm
by foragefarmer
5 Replies
529 Views
Last post September 02, 2014, 10:11:11 pm
by farmboy
5 Replies
602 Views
Last post September 03, 2014, 11:53:37 pm
by 3000 FPS
16 Replies
406 Views
Last post May 20, 2015, 08:14:53 pm
by 3000 FPS
14 Replies
344 Views
Last post July 27, 2015, 11:27:14 am
by pigpen60