Author Topic: can i put a 372 jug on a 570 there junk stroke the same  (Read 296 times)

0 Members and 0 Guests are viewing this topic.

Offline huguenot ny

  • 3 cube
  • *
  • Posts: 5
  • Karma: 0
can i put a 372 jug on a 570 there junk stroke the same
« on: May 22, 2012, 01:41:08 am »
just wondering if i can do this on my 570 the things a piece of junk new ring good compression pops every time you pull it just will not go never been stumped with saws before this thing is garbage can even get new ring to seat good compression 120 with 1 pul pops 3 pulls she is at 140-145 but still only pops what is going on with this thing. help me i am pulling out my hair and i have none.

Share on Facebook Share on Twitter


Offline rms61moparman

  • 6 cube
  • ****
  • Posts: 270
  • Karma: 37
  • Location: Franklinton, Kentucky

Sounds like a timing issue.
Have you checked the flywheel, keyway and crank?


Mike

Online mweba

  • Piped Saw
  • *****
  • Posts: 390
  • Karma: 53
Will it run when primed?  Do you have a know good ignition to swap onto the saw?  145psi is normal for these saws and plenty of compression to run well.


Is there any play in the bearings?

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22054
  • Karma: 546
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
WAG: have you checked seals etc for leaks.

Did you figure out why it needed rebuild (what had caused problems in first place). How was it running before you pulled it down etc.
REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
13 Replies
849 Views
Last post March 02, 2017, 03:25:07 pm
by Cut4fun .
13 Replies
1683 Views
Last post January 28, 2014, 06:23:28 pm
by 660magnum
41 Replies
3121 Views
Last post May 04, 2019, 10:18:45 am
by Cut4fun .
6 Replies
369 Views
Last post February 11, 2015, 04:57:38 pm
by dutchsawdoctor
11 Replies
630 Views
Last post December 25, 2019, 11:35:14 am
by Heavycutter66
0 Replies
70 Views
Last post May 18, 2015, 01:46:12 pm
by Cut4fun .
4 Replies
222 Views
Last post July 24, 2015, 11:55:16 pm
by 3000 FPS
7 Replies
539 Views
Last post March 10, 2016, 06:30:18 pm
by Philbert
8 Replies
2028 Views
Last post May 14, 2016, 01:07:44 pm
by Cut4fun .
3 Replies
201 Views
Last post June 01, 2018, 02:18:54 pm
by Cut4fun .