« previous next »
Pages: 1 2 3 4 [5] 6   Go Down

Author Topic: Coil to flywheel air gap tool?  (Read 5231 times)

0 Members and 21 Guests are viewing this topic.

Offline eriksat1

  • 4 cube
  • **
  • Posts: 51
  • Karma: 4

    • Total Badges: 11
    Badges: (View All)
    Level 3 One year Anniversary 10 Posts Combination Topic Starter Level 2
Re: Coil to flywheel air gap tool?
« Reply #40 on: February 23, 2014, 12:02:09 pm »
I'm sure there are also places that sell steel shim stock, it would be a little more work to cut to the size you wanted and smooth the edges though. It is funny they don't make a steel tool at .012" One would last you a life time.

I just found a place that sells .012" stainless steel shim stock 6" x 50" roll for $18.78 you could make about 25 tools out of a roll and sell them for $5 each.
Logged
Pages: 1 2 3 4 [5] 6   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
0 Replies
302 Views 		Last post March 26, 2012, 08:02:32 pm
by Snoopy
6 Replies
1097 Views 		Last post October 14, 2012, 02:20:05 pm
by Jim372xp
3 Replies
578 Views 		Last post January 17, 2013, 07:33:10 pm
by jmester
18 Replies
1633 Views 		Last post October 27, 2013, 09:26:23 pm
by 660magnum
0 Replies
170 Views 		Last post February 09, 2014, 06:15:03 pm
by 295tramp
12 Replies
3786 Views 		Last post March 27, 2016, 01:48:26 pm
by gregh
11 Replies
767 Views 		Last post May 16, 2014, 08:01:40 am
by KilliansRedLeo
p 41 flywheel

Started by Bob « 1 2 » Pioneer

15 Replies
1970 Views 		Last post June 05, 2014, 08:49:36 pm
by KilliansRedLeo
31 Replies
1284 Views 		Last post November 25, 2014, 07:12:07 am
by Al Smith
23 Replies
1974 Views 		Last post November 04, 2014, 03:13:07 pm
by bloodontheice