Author Topic: Deck Height Difference in XT Cases Versus XP Cases  (Read 829 times)

0 Members and 0 Guests are viewing this topic.

Offline SawTroll

  • Nitro Hotsaw
  • *******
  • Posts: 1196
  • Karma: 68
  • Information collector
  • Location: Troms, North Norway
Re: Deck Height Difference in XT Cases Versus XP Cases
« on: May 06, 2014, 09:04:24 am »
Here was the info.

I've never had the need to mess with one of those impulse pipes myself. But you'd think that there would be instances where someone might need to order that as a spare part.

One thing to add here regarding cases is that there is a difference between the originals vs the new X-torq models. The skirt on the bottom of the XT cylinders is deeper than the originals, so the corresponding cut in the XT cases is also deeper. If putting an original jug on an XT case, you will have no problem. But you cannot put an XT cylinder on the original case. (unless you do some grinding) As far as deck height, I really can't say.

That isn't about deck height, as I read it, but about the cutouts for the cylinder "skirt" (going below deck height).

 

Related Topics

  Subject / Started by Replies Last post
7 Replies
647 Views
Last post March 07, 2011, 07:26:21 pm
by SawTroll
1 Replies
355 Views
Last post November 04, 2012, 06:06:06 pm
by rms61moparman
3 Replies
140 Views
Last post December 14, 2013, 02:00:48 pm
by KilliansRedLeo
9 Replies
391 Views
Last post March 10, 2014, 03:15:01 pm
by 660magnum
6 Replies
228 Views
Last post November 27, 2015, 04:00:08 pm
by weimedog
0 Replies
140 Views
Last post April 07, 2016, 01:45:10 pm
by Cut4fun .
0 Replies
319 Views
Last post April 26, 2017, 08:51:22 pm
by dudechuck