Author Topic: Husqvarna k760 speed problen  (Read 159 times)

0 Members and 0 Guests are viewing this topic.

Offline Vikmata

  • pruner
  • *
  • Posts: 1
  • Karma: 0
Husqvarna k760 speed problen
« on: October 30, 2017, 10:56:39 am »
I have replaces the piston and sparplug but stays the same until time goes by then it warms up and cuts fine but if i run out of gas by the time i start it again is the same thing. 

Can it be a clutch problem?

Share on Facebook Share on Twitter


Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 21945
  • Karma: 533
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Husqvarna k760 speed problen
« Reply #1 on: October 30, 2017, 04:24:31 pm »
@3000 FPS has messed with these.
REDNECK Saw Repair Getter Done

Online 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4464
  • Karma: 274
  • Location: Carpenter, Wyoming
Re: Husqvarna k760 speed problen
« Reply #2 on: October 30, 2017, 06:53:53 pm »
I would check the belt on it to make sure it is in good shape and has the correct tension.   Then I would check the clutch to make sure it is in good shape.   

If the engine is running ok but the blade has stopped spinning when cutting into concrete or pavers then it is not the carb. 
PP 505, 475, 445.

 

Related Topics

  Subject / Started by Replies Last post
1 Replies
1045 Views
Last post November 28, 2011, 11:44:35 am
by bloodontheice
34 Replies
3835 Views
Last post August 02, 2014, 04:07:59 pm
by 630 red
38 Replies
1927 Views
Last post February 13, 2019, 01:55:47 pm
by HolmenTree
22 Replies
514 Views
Last post April 16, 2016, 07:22:41 am
by jmester
2 Replies
115 Views
Last post September 15, 2017, 10:04:32 pm
by joe_indi
1 Replies
147 Views
Last post September 18, 2017, 08:38:44 pm
by 3000 FPS
2 Replies
237 Views
Last post January 07, 2018, 08:12:37 pm
by jmester
18 Replies
325 Views
Last post January 20, 2018, 08:15:54 pm
by mdavlee .
0 Replies
124 Views
Last post June 07, 2018, 09:29:37 am
by Cut4fun .
5 Replies
88 Views
Last post May 05, 2020, 09:30:13 am
by ray benson