Author Topic: Husky 272 FlyWheel  (Read 202 times)

0 Members and 0 Guests are viewing this topic.

Offline EHP

  • Gas Hotsaw
  • ******
  • Posts: 589
  • Karma: 72
Re: Husky 272 FlyWheel
« Reply #10 on: April 11, 2015, 08:07:03 am »
last 272's had the cast in key in the flywheel

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Husky 272 FlyWheel
« Reply #11 on: April 11, 2015, 02:25:15 pm »
I need to check the SN on my 272XP.  It's a 1996 or 1997 production saw IIRC...
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

Offline EHP

  • Gas Hotsaw
  • ******
  • Posts: 589
  • Karma: 72
Re: Husky 272 FlyWheel
« Reply #12 on: April 11, 2015, 08:56:05 pm »
we never had any trouble with the molded flywheel until they were running on alcohol/nitro and on pipe , on muffler no problems but anybody that has seem how those little 272 turn up on rpms and how fast they spin it up

 

Related Topics

  Subject / Started by Replies Last post
6 Replies
544 Views
Last post October 14, 2012, 02:20:05 pm
by Jim372xp
3 Replies
291 Views
Last post January 17, 2013, 07:33:10 pm
by jmester
5 Replies
487 Views
Last post January 16, 2014, 08:23:24 pm
by alsled
p 41 flywheel

Started by Bob « 1 2 » Pioneer

15 Replies
1007 Views
Last post June 05, 2014, 08:49:36 pm
by KilliansRedLeo
31 Replies
452 Views
Last post November 25, 2014, 07:12:07 am
by Al Smith
15 Replies
332 Views
Last post December 05, 2014, 01:30:49 pm
by aclarke
1 Replies
97 Views
Last post March 10, 2015, 08:41:58 am
by Jason K
10 Replies
151 Views
Last post December 07, 2015, 07:07:45 am
by Moparmyway
6 Replies
337 Views
Last post January 02, 2016, 11:17:33 am
by Al Smith
5 Replies
148 Views
Last post July 20, 2016, 07:33:47 pm
by 1manband