Author Topic: Husky Special 50 Still not starting  (Read 1054 times)

0 Members and 41 Guests are viewing this topic.

Offline 660magnum

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 6437
  • Karma: 249
  • For The Love Of Chainsaws
  • Location: NCO

  • Total Badges: 39
    Badges: (View All)
    Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary Fourth year Anniversary 5000 Posts Third year Anniversary
Re: Husky Special 50 Still not starting
« on: April 21, 2014, 08:59:30 am »
Tune the low needle for best running with the throttle locked.

Before unlocking the throttle screw "in" the idle speed adjustment.

Unlock the throttle and try again for best running at idle.

Keep working at it until you get the saw speed down low enough that the chain doesn't spin.

Now you must get the engine where it will accelerate which will involve screwing out the low speed needle to where the engine will take the throttle.

Start with the needles at two turns . . .

We can talk about the high speed screw after you get the chainsaw to idle and accelerate?
We should share what we know... someone may learn...
That knowledge can live after us... and that "Pays It Forward".
Be all that you can be . . .

 

Related Topics

  Subject / Started by Replies Last post
12 Replies
2055 Views
Last post December 11, 2014, 02:51:35 am
by Hoggwood
5 Replies
1642 Views
Last post July 04, 2012, 05:29:50 pm
by SawTroll
ms361 not starting

Started by haasper « 1 2 3 » Stihl

22 Replies
3442 Views
Last post December 28, 2012, 04:42:43 pm
by 660magnum
3 Replies
457 Views
Last post February 20, 2013, 04:39:47 pm
by Cut4fun .
24 Replies
1224 Views
Last post April 09, 2014, 10:47:19 pm
by JohnG28
2 Replies
432 Views
Last post July 06, 2014, 08:25:56 am
by bardos
7 Replies
645 Views
Last post October 17, 2014, 10:56:51 pm
by Randy
0 Replies
273 Views
Last post June 20, 2015, 12:02:22 pm
by Cut4fun .
6 Replies
1726 Views
Last post December 23, 2016, 04:52:43 am
by DNX800
0 Replies
273 Views
Last post August 23, 2018, 07:47:32 pm
by John Mc