Author Topic: Husky Special 50 Still not starting  (Read 1049 times)

0 Members and 18 Guests are viewing this topic.

Offline jrbarba

  • 3 cube
  • *
  • Posts: 21
  • Karma: 1

  • Total Badges: 13
    Badges: (View All)
    One year Anniversary 10 Posts Level 3 Karma Level 2 Linux User
Re: Husky Special 50 Still not starting
« on: April 21, 2014, 09:03:57 am »
Tune the low needle for best running with the throttle locked.

Before unlocking the throttle screw "in" the idle speed adjustment.

Unlock the throttle and try again for best running at idle.

Keep working at it until you get the saw speed down low enough that the chain doesn't spin.

Now you must get the engine where it will accelerate which will involve screwing out the low speed needle to where the engine will take the throttle.

Start with the needles at two turns . . .

We can talk about the high speed screw after you get the chainsaw to idle and accelerate?

That's the problem, the saw won't run long enough (when starter fluid burns, it stops dead) to adjust anything.

 

Related Topics

  Subject / Started by Replies Last post
12 Replies
2055 Views
Last post December 11, 2014, 02:51:35 am
by Hoggwood
5 Replies
1642 Views
Last post July 04, 2012, 05:29:50 pm
by SawTroll
ms361 not starting

Started by haasper « 1 2 3 » Stihl

22 Replies
3442 Views
Last post December 28, 2012, 04:42:43 pm
by 660magnum
3 Replies
457 Views
Last post February 20, 2013, 04:39:47 pm
by Cut4fun .
24 Replies
1223 Views
Last post April 09, 2014, 10:47:19 pm
by JohnG28
2 Replies
432 Views
Last post July 06, 2014, 08:25:56 am
by bardos
7 Replies
645 Views
Last post October 17, 2014, 10:56:51 pm
by Randy
0 Replies
273 Views
Last post June 20, 2015, 12:02:22 pm
by Cut4fun .
6 Replies
1726 Views
Last post December 23, 2016, 04:52:43 am
by DNX800
0 Replies
273 Views
Last post August 23, 2018, 07:47:32 pm
by John Mc