Chainsaw Repair

1) Don't use starting fluid in a two stroke engine
1a) Make sure that you have no kinks or sharp bends in the new fuel line
2) Get yourself a squirt bottle that you can use to squirt a little pre mix in the carb
3) Set the H&L jets at 1 turn out from lightly seated
4) Start pulling with the saw choked
5) When the saw fires return the choke to the run position but do not pull the trigger because the throttle is automatically set to fast idle by previous setting the choke to on
6) Pull again a couple of times, saw should start or at least fire a couple of times

Plus what 660 said above!