Author Topic: Husqavarna 445  (Read 161 times)

0 Members and 0 Guests are viewing this topic.

Offline jackcu

  • pruner
  • *
  • Posts: 2
  • Karma: 0
Husqavarna 445
« on: February 28, 2016, 09:18:01 am »
My saw will start up and run at high RPM but when rpms get low it will die every time. Tried adjusting throttle screw and L RPM her but no luck so far. Any other suggestions, should I remove carb and clean? Thanks of any hints.

Share on Facebook Share on Twitter


Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 21952
  • Karma: 535
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Husqavarna 445
« Reply #1 on: February 28, 2016, 09:24:52 am »
My WAG.  Maybe the carb has epa stops on the L.   Trim the plastic tab off.  Guessing here. Now open the L up now till you have good throttle on/off the trgger. Adjust the I idle now till it idles with the fatter L. 

My guess is the L is to lean and you cant get enough adjustment with the epa tab on the needle.
REDNECK Saw Repair Getter Done

Offline jackcu

  • pruner
  • *
  • Posts: 2
  • Karma: 0
Re: Husqavarna 445
« Reply #2 on: February 28, 2016, 11:18:33 am »
Thank you. I will check that

 

Related Topics

  Subject / Started by Replies Last post
20 Replies
362 Views
Last post April 26, 2018, 12:37:38 pm
by Cut4fun .