Author Topic: Husqvarna 3120XP Sprocket Pin Sizes  (Read 1405 times)

0 Members and 0 Guests are viewing this topic.

Offline Al Smith

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2743
  • Karma: 163
Re: Husqvarna 3120XP Sprocket Pin Sizes
« on: October 12, 2012, 10:08:18 pm »
The actual spur itself would not be hard to do .Broaching  the splines for the drive would be a real challange .Larry S had a 10 spur gear on a saw I think that was done by Ken Dunn .I think it was souped 090 .I ran the thing but oddly can't remember what it was .John Lambert also had a tall gear deal but I can't remember that one either .Fact as I think back big Dave N had an 066 with a ten spur 3/8"

What everyone has to remember when you get into those tall gears you have to have a modified bar with more heel to it else it will fling chains .Not good at all .

Ha I tried to pull a ten pin type on a Mac 125 in .404 .It would pull it but it didn't like it .It was one of those deals where the thing was one unit,drum and drive were one piece .That was about the time I came to the realization not to  use a 125 McCulloch as a cookie cutter and use it for what it was built for ,big wood .

 

Related Topics

  Subject / Started by Replies Last post
3120xp 9T

Started by Cut4fun « 1 2 » Husqvarna

12 Replies
771 Views
Last post March 26, 2014, 09:58:39 am
by SawTroll
2 Replies
131 Views
Last post August 03, 2013, 06:29:12 am
by Cut4fun .
1 Replies
157 Views
Last post October 10, 2013, 10:18:54 pm
by 660magnum
1 Replies
163 Views
Last post November 05, 2013, 12:38:23 am
by Eccentric
9 Replies
446 Views
Last post January 24, 2014, 01:18:49 pm
by Cut4fun .
9 Replies
1321 Views
Last post February 02, 2014, 07:45:35 pm
by countryhog
4 Replies
350 Views
Last post October 11, 2014, 02:49:04 pm
by KilliansRedLeo
2 Replies
115 Views
Last post April 14, 2015, 08:48:14 pm
by deereguy
4 Replies
200 Views
Last post March 16, 2017, 04:37:50 am
by bulletpruf
0 Replies
78 Views
Last post February 05, 2019, 08:18:46 pm
by Cut4fun .