Author Topic: Husqvarna 346xp won't high rev  (Read 504 times)

0 Members and 0 Guests are viewing this topic.

Offline Bluegill

  • 5 cube
  • ***
  • Posts: 141
  • Karma: 22
Re: Husqvarna 346xp won't high rev
« Reply #10 on: October 29, 2013, 02:16:26 pm »
Also, does the chain move around the bar freely by hand?

Take Cut4fun up on his offer, if you are close...

Offline Adirondackstihl

  • 6 cube
  • ****
  • Posts: 176
  • Karma: 8
  • Location: Champlain, NY
Re: Husqvarna 346xp won't high rev
« Reply #11 on: October 30, 2013, 01:01:22 pm »
If the "H" was lean enough to keep it from revving, I would have to say the saw would just fall on its face and die.
Even pig rich, I think the saw would still rev.......not 14k+, but it would still rev.
I'm leaning towards a carb issue. Is the choke / throttle interlock working correctly? Sounds like its running on full choke?

Offline Bluegill

  • 5 cube
  • ***
  • Posts: 141
  • Karma: 22
Re: Husqvarna 346xp won't high rev
« Reply #12 on: November 01, 2013, 01:45:00 pm »
Did we ever figure out what was wrong with this one?

Offline Cut4fun

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 4118
  • Karma: 170
  • OHIO REDNECK
Re: Husqvarna 346xp won't high rev
« Reply #13 on: November 02, 2013, 12:01:50 pm »
Did we ever figure out what was wrong with this one?

I was wondering too.
REDNECK Saw Repair

 

Related Topics

  Subject / Started by Replies Last post
2 Replies
914 Views
Last post March 02, 2011, 09:12:47 pm
by Cut4fun
44 Replies
4016 Views
Last post July 25, 2019, 09:38:53 am
by Cut4fun .
4 Replies
826 Views
Last post February 08, 2012, 04:48:11 pm
by SawTroll
0 Replies
1271 Views
Last post February 05, 2013, 05:02:27 pm
by Cut4fun .
1 Replies
271 Views
Last post October 06, 2013, 01:26:57 pm
by Cut4fun .
12 Replies
1167 Views
Last post October 08, 2013, 01:40:04 pm
by Cut4fun
4 Replies
369 Views
Last post February 14, 2014, 04:10:00 pm
by Cut4fun .
10 Replies
1127 Views
Last post November 22, 2013, 02:41:13 pm
by Cut4fun
12 Replies
614 Views
Last post June 25, 2014, 04:45:09 pm
by Jason K
2 Replies
176 Views
Last post November 24, 2014, 08:54:41 am
by sharkey