Author Topic: Husqvarna 371xp ported  (Read 1454 times)

0 Members and 8 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23708
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

  • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Re: Husqvarna 371xp ported
« on: August 08, 2013, 03:53:49 pm »
I got pics of outside cylinder.  No mahle anywhere.

Also before pulling cylinder I had another thought.  Called owner and ran it by him I got a ok to do.

Anyhow the saw has spark and fuel and pops a couple times.  So I start thinking timing.  Pull it down again get ready to remove flywheel then I thought to myself I will check timing before pulling fly off.  It all seemed normal except one thing I noticed by eyeing it.  Coil gap looked real tight. So I tried to slide a business card in there and bingo.  Loosen coil and Set gap fired up.  No marks where it had contacted the flywheel etc.

Retuned carb and seems good so far.  Checked squish on front and rear with cyl still attached, before all of the above and was getting 18.5-20 squish which is super tight for only 148psi.  IMO. 

 

Related Topics

  Subject / Started by Replies Last post
37 Replies
2754 Views
Last post August 20, 2014, 11:35:33 am
by JohnG28
7 Replies
932 Views
Last post December 04, 2011, 03:28:34 pm
by Al Smith
108 Replies
2899 Views
Last post March 07, 2014, 10:47:29 am
by KilliansRedLeo
16 Replies
981 Views
Last post May 02, 2014, 09:50:35 am
by KilliansRedLeo
3 Replies
406 Views
Last post July 31, 2014, 01:22:55 am
by 3000 FPS
4 Replies
481 Views
Last post August 09, 2014, 04:39:02 pm
by SawTroll
1 Replies
333 Views
Last post November 08, 2014, 06:33:26 am
by Moparmyway
7 Replies
420 Views
Last post January 28, 2017, 09:39:04 pm
by Cut4fun .
2 Replies
682 Views
Last post February 16, 2018, 10:41:31 pm
by farmboy
0 Replies
351 Views
Last post March 21, 2019, 10:42:16 am
by Cut4fun .