« previous next »
Pages: 1 [2] 3   Go Down

Author Topic: Husqvarna 371xp ported  (Read 1475 times)

0 Members and 54 Guests are viewing this topic.

Offline 660magnum

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 6437
  • Karma: 249
  • For The Love Of Chainsaws
  • Location: NCO

    • Total Badges: 39
    Badges: (View All)
    Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary Fourth year Anniversary 5000 Posts Third year Anniversary
Re: Husqvarna 371xp ported
« Reply #10 on: August 09, 2013, 01:31:03 pm »
I think the coil was touching just enough to short it out. I wasn't making a noticeable mark on the coil armature or the flywheel. It didn't always touch but the bearing eventually became loose enough that it did. Most likely the coil armature and the flywheel only touched when the magnets both came around as that was when the magnetic attraction was the strongest.
Logged
We should share what we know... someone may learn...
That knowledge can live after us... and that "Pays It Forward".
Be all that you can be . . .
Pages: 1 [2] 3   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
37 Replies
2777 Views 		Last post August 20, 2014, 11:35:33 am
by JohnG28
7 Replies
939 Views 		Last post December 04, 2011, 03:28:34 pm
by Al Smith
108 Replies
2977 Views 		Last post March 07, 2014, 10:47:29 am
by KilliansRedLeo
16 Replies
1001 Views 		Last post May 02, 2014, 09:50:35 am
by KilliansRedLeo
3 Replies
408 Views 		Last post July 31, 2014, 01:22:55 am
by 3000 FPS
4 Replies
484 Views 		Last post August 09, 2014, 04:39:02 pm
by SawTroll
1 Replies
335 Views 		Last post November 08, 2014, 06:33:26 am
by Moparmyway
7 Replies
426 Views 		Last post January 28, 2017, 09:39:04 pm
by Cut4fun .
2 Replies
691 Views 		Last post February 16, 2018, 10:41:31 pm
by farmboy
0 Replies
351 Views 		Last post March 21, 2019, 10:42:16 am
by Cut4fun .