Author Topic: husqvarna 372 x torq??  (Read 2775 times)

0 Members and 3 Guests are viewing this topic.

Offline blsnelling

  • 4 cube
  • **
  • Posts: 58
  • Karma: 7
Re: husqvarna 372 x torq??
« Reply #10 on: May 03, 2011, 09:49:54 pm »
The new 372XP X-Torq is definately stratofied.  However, they built the saw off the same crankcase as the 372 we have always had.  It does use a single venturi to feed both the clean air and the fuel charged air.  The carb has a divider in it so that only one half of it takes on fuel.  This divider continues through the intake duct and into the cylinder.  I have not modified a 575, so can't really tell you how it compares.  Hope that helps a little.

 

Related Topics

  Subject / Started by Replies Last post
127 Replies
14482 Views
Last post December 26, 2012, 10:16:57 am
by Cut4fun
2 Replies
788 Views
Last post July 23, 2012, 07:49:15 am
by 660magnum
9 Replies
1390 Views
Last post November 17, 2012, 09:05:18 pm
by Mw1995
5 Replies
499 Views
Last post January 05, 2013, 11:35:08 pm
by 660magnum
0 Replies
158 Views
Last post March 03, 2013, 08:14:40 pm
by Cut4fun
19 Replies
1115 Views
Last post November 10, 2013, 08:11:53 pm
by KilliansRedLeo
7 Replies
381 Views
Last post February 28, 2016, 07:32:00 pm
by 660magnum
2 Replies
222 Views
Last post May 07, 2018, 02:36:08 pm
by Cut4fun .
4 Replies
340 Views
Last post July 12, 2018, 09:03:40 am
by ray benson
12 Replies
205 Views
Last post October 19, 2022, 08:30:49 pm
by EHP