« previous next »
Pages: [1]   Go Down

Author Topic: Husqvarna 372xp wont stay running  (Read 2709 times)

0 Members and 0 Guests are viewing this topic.

Offline huskyman

  • 3 cube
  • *
  • Posts: 15
  • Karma: 0
Husqvarna 372xp wont stay running
« on: January 23, 2012, 10:42:25 pm »
Hello everyone I have a fully rebuilt 372xp. I put a new piston cylinder and rings and gasket in it. It has a new intake, replaced the fuel line filter and impulse line. Rebuilt the carb and dialed it in. It fires up easly and sounds great for about 15-20 seconds then stutters and then dies. It takes a minute to start it again and requires me to give it full throttle to start it. Any ideas?
Logged

Share on Bluesky Share on Facebook

Offline w8ye

  • 5 cube
  • ***
  • Posts: 117
  • Karma: 5
Re: Husqvarna 372xp wont stay running
« Reply #1 on: January 23, 2012, 11:33:49 pm »
You need to check out all the vitals next time it quits

Do you have Spark?

Is the plug wet?

Logged

Offline Magnus

  • 6 cube
  • ****
  • Posts: 237
  • Karma: 26
  • Location: Sweden
    • Chainsaw Collectors Forum
Re: Husqvarna 372xp wont stay running
« Reply #2 on: January 24, 2012, 04:36:18 am »
Sounds as it chokes itself.
Wrong carb settings on Main inlet needle or jets could do this.
A ignition that has not decided if it is broke or not could do it too...
Logged
Chainsaw nut!
Useful Useful x 1 View List

Offline huskyman

  • 3 cube
  • *
  • Posts: 15
  • Karma: 0
Re: Husqvarna 372xp wont stay running
« Reply #3 on: February 21, 2012, 12:25:42 am »
I had this happen twice to me once on a 026 and a 394. Both times they would idle then die, I replaced the coil on both and they ran perfect. Hope that helps!
Logged
Useful Useful x 1 View List

Offline mweba

  • Piped Saw
  • *****
  • Posts: 392
  • Karma: 55
Re: Husqvarna 372xp wont stay running
« Reply #4 on: February 21, 2012, 09:43:13 am »
These are the common symptoms of a main jet nozzle.  The nozzle can be replaced but most go the carb replace route.      This could also be a tank vent issue.  Good luck
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
5 Replies
1747 Views 		Last post January 02, 2013, 08:23:58 am
by William Greene
17 Replies
1896 Views 		Last post March 08, 2013, 04:08:19 pm
by brokenbudget
17 Replies
3903 Views 		Last post November 25, 2013, 01:09:47 pm
by crankincraig
4 Replies
785 Views 		Last post June 20, 2014, 09:24:30 am
by Fish
2 Replies
1160 Views 		Last post September 12, 2015, 09:44:05 pm
by jrdplowing
16 Replies
2125 Views 		Last post January 27, 2017, 04:35:28 pm
by Fishinmech24
2 Replies
1003 Views 		Last post December 30, 2015, 03:58:15 pm
by Cat-Face Timber
11 Replies
5199 Views 		Last post June 05, 2017, 02:48:32 pm
by 3000 FPS
2 Replies
1465 Views 		Last post July 04, 2018, 08:14:36 am
by Cut4fun .
2 Replies
651 Views 		Last post August 31, 2018, 10:10:01 am
by Cut4fun .