Author Topic: Husqvarna 372  (Read 8669 times)

0 Members and 0 Guests are viewing this topic.

Offline blsnelling

  • 4 cube
  • **
  • Posts: 58
  • Karma: 7
Re: Husqvarna 372xp
« Reply #10 on: February 26, 2011, 01:53:52 pm »
Use some really nasty solvents and give it some good heating to burn out as much oil as possible before applying whatever sealant.

One possible to use in a fine crack like this is Locktite. Seap it in and seal with some tape for a while, Locktite hardens from lack of air.
What concerns me about this crack is that it's in the bar mount area and sees some stresses.  I'm not sure you'd want to split the cases, but the best fix would be from inside.  Drill small holes at both ends of the crack, bevel the crack a little, rough up real good around it, and then JBWeld it.  I did a similiar repair to a 015 and my BIL is still using it.

 

Related Topics

  Subject / Started by Replies Last post
7 Replies
1725 Views
Last post November 20, 2011, 03:28:21 pm
by SawTroll
Husqvarna 66

Started by Cut4fun « 1 2 3 » Husqvarna

24 Replies
2251 Views
Last post June 19, 2020, 05:49:02 am
by Spike60
3 Replies
230 Views
Last post March 21, 2011, 05:40:40 pm
by Kjell S
Husqvarna 268

Started by Cut4fun « 1 2 ... 18 19 » Husqvarna

182 Replies
17882 Views
Last post August 12, 2020, 07:23:07 am
by Cut4fun .
2 Replies
214 Views
Last post March 04, 2012, 02:35:58 pm
by Cut4fun .
224 Replies
10611 Views
Last post October 12, 2020, 09:10:19 am
by Cut4fun .
0 Replies
399 Views
Last post November 26, 2016, 02:35:22 pm
by weimedog
0 Replies
148 Views
Last post October 29, 2017, 09:09:27 pm
by weimedog
21 Replies
3559 Views
Last post June 20, 2021, 08:45:44 am
by Cut4fun
8 Replies
99 Views
Last post June 05, 2021, 07:45:52 am
by Cut4fun