Author Topic: Husqvarna 372xp  (Read 8186 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 21879
  • Karma: 522
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Husqvarna 372xp
« Reply #50 on: May 28, 2011, 03:23:40 pm »
I never thought of  using a  vise.

I just changed them out. Heat oven to 200 degrees. Put both halves in. Pull one out and used socket to drive out. Put back in oven after cleaned up. Pull other one out drive out with socket. Put back in and pull the first one out and use socket to drive the new bearing in. Same thing on next one.


Will have to try the vise method sometime. Thanks for slick trick.
REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
1157 Views
Last post February 21, 2012, 09:43:13 am
by mweba
32 Replies
992 Views
Last post March 26, 2013, 02:48:36 pm
by UNCLEBEEF
5 Replies
333 Views
Last post September 14, 2013, 11:32:12 am
by turbo885
7 Replies
649 Views
Last post October 23, 2013, 10:49:55 pm
by Walt
14 Replies
1152 Views
Last post December 22, 2013, 06:21:33 am
by brokenbudget
17 Replies
389 Views
Last post January 29, 2015, 10:28:10 am
by Spike60
15 Replies
399 Views
Last post September 07, 2015, 06:40:03 pm
by Cut4fun .
6 Replies
418 Views
Last post December 06, 2016, 08:09:47 am
by wild262
2 Replies
91 Views
Last post May 07, 2018, 02:36:08 pm
by Cut4fun .
8 Replies
373 Views
Last post January 05, 2019, 09:48:58 am
by trappermike