Author Topic: Husqvarna 41 oil tank leak  (Read 639 times)

0 Members and 0 Guests are viewing this topic.

Offline lowvirtualmemory

  • 3 cube
  • *
  • Posts: 5
  • Karma: 1
Re: Husqvarna 41 oil tank leak
« on: April 26, 2017, 11:14:45 pm »
I can't seem to work up much enthusiasm for trying to re-glue, unless I make a winter project out of it or something. I did rough up the area with fine grit sandpaper and even tried some PVC primer (lol) as well. out of desperation. Never seen the quick steel epoxy before in my area (eastern KY) before, don't think. I'll look for some the next time I'm in the vicinity of an HD or maybe A-Zone.

There's an older Echo saw, plus a couple of the PP 42cc saws for sale in my area. Echo is a good saw, I believe. I used to have an Echo weed trimmer, and it was outstanding in every respect. I think Echo and Shindaiwa are both made by the same manufacturer in Japan. Don't know a whole lot about the newer PP's. Used to have an older used one, years and years ago, that wasn't much. But I think it was one of the smaller, junkier models, about 32cc's or so. d But did'nt I read somewhere or other that the PP Pro line are now made by Husqvarna or Jonsered? If so, might be worth looking at or trying out. Still a doubter about Poulan though.

 

Related Topics

  Subject / Started by Replies Last post
7 Replies
438 Views
Last post November 09, 2011, 08:27:22 pm
by man of stihl
2 Replies
813 Views
Last post August 14, 2012, 08:16:15 pm
by woodyweeder
7 Replies
660 Views
Last post August 25, 2013, 04:43:37 pm
by 660magnum
0 Replies
129 Views
Last post September 26, 2013, 10:14:34 am
by KilliansRedLeo
3 Replies
216 Views
Last post November 13, 2013, 10:53:09 pm
by jcsmith
9 Replies
739 Views
Last post November 15, 2014, 10:00:21 pm
by 3000 FPS
11 Replies
208 Views
Last post August 19, 2014, 08:19:54 pm
by basod
5100s air leak

Started by dolmar « 1 2 3 » Dolmar Makita

21 Replies
493 Views
Last post January 16, 2015, 04:12:20 am
by dolmarfan
1 Replies
198 Views
Last post May 01, 2016, 05:07:29 pm
by 660magnum
1 Replies
472 Views
Last post September 17, 2017, 10:19:30 pm
by Cut4fun .