Author Topic: Husqvarna 435 bar mount stud  (Read 137 times)

0 Members and 0 Guests are viewing this topic.

Offline wild262

  • 6 cube
  • ****
  • Posts: 161
  • Karma: 29
Re: Husqvarna 435 bar mount stud
« on: April 03, 2015, 09:25:53 am »
Also on some saws like the 350 series, theres a metal channel support (I call it) that helps distribute the pressure against the case that is between the stud and case.   If your saw has it, then it should still be in there providing the other stud hasn't fallen out prior.   I use a long locking 8" pair of forceps to re-position these.   I had a 435 once, but never had any problems with it, and was a good saw for light limbing.  Hope this helps ya.  :)

 

Related Topics

  Subject / Started by Replies Last post
5 Replies
1397 Views
Last post June 17, 2011, 11:35:12 pm
by SawTroll
stihl bar stud repair

Started by mweba « 1 2 » Stihl

12 Replies
2698 Views
Last post September 09, 2019, 09:42:41 am
by joe_indi
3 Replies
190 Views
Last post August 17, 2013, 10:20:27 pm
by cowroy
1 Replies
163 Views
Last post November 05, 2013, 12:38:23 am
by Eccentric
10 Replies
231 Views
Last post December 31, 2013, 06:13:12 pm
by 3000 FPS
Broken Bar Stud 039

Started by BSW « 1 2 » Stihl

11 Replies
280 Views
Last post February 23, 2014, 04:08:33 am
by bustedknuckles
5 Replies
586 Views
Last post September 03, 2014, 11:53:37 pm
by 3000 FPS
7 Replies
302 Views
Last post September 02, 2014, 03:29:39 pm
by Nathaniel Vansickle
13 Replies
757 Views
Last post October 23, 2019, 10:56:27 am
by Cut4fun .
0 Replies
82 Views
Last post September 09, 2019, 09:38:40 am
by joe_indi