Author Topic: husqvarna 445 fuel bulb replace  (Read 2325 times)

0 Members and 58 Guests are viewing this topic.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

  • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: husqvarna 445 fuel bulb replace
« on: November 06, 2013, 07:57:16 pm »
ok, I figured it out
I took out the air filter and the 4 screws holding the black plate on the carb body. the loosed the plate enough to move it a little back out of the orange hole the primer bulb sits in and then I was able to see one of the barbed clips on the top side and took a small flat screwdriver and pushed down and out and it popped out with the 2 fuel lines attached. I used a small pair of needle nose pliers to gently pull the bulb out until I could grab the 2 fuel lines and pull them out enough to get both off the old bulb and replace with the new one. Once I figured it out it took maybe 2 minutes to remove the old and replace with the new one.

I probably didn't need to even remove the 4 screws after looking at that.
good luck
 

I hope you remember which fuel line went where on the purge bulb.   It makes a difference.   The bulb actually purges the air out of the lines and carburetor.
PP 505, 475, 445.

 

Related Topics

  Subject / Started by Replies Last post
6 Replies
1143 Views
Last post January 11, 2013, 05:01:34 pm
by Cut4fun .
3 Replies
606 Views
Last post October 06, 2013, 09:51:24 pm
by Eccentric
1 Replies
327 Views
Last post January 21, 2014, 10:12:33 pm
by Eccentric
8 Replies
856 Views
Last post March 12, 2014, 09:42:07 am
by KilliansRedLeo
10 Replies
1029 Views
Last post April 16, 2015, 08:12:11 pm
by SawTroll
8 Replies
591 Views
Last post September 13, 2015, 02:47:57 pm
by jrdplowing
2 Replies
707 Views
Last post February 02, 2016, 07:30:39 pm
by Cycledude
2 Replies
748 Views
Last post July 17, 2016, 09:26:05 pm
by Nathaniel Vansickle
4 Replies
422 Views
Last post February 27, 2017, 05:53:53 am
by dmccann
7 Replies
1007 Views
Last post April 07, 2018, 11:26:54 am
by sidgeorge