« previous next »
Pages: [1] 2   Go Down

Author Topic: Husqvarna 45  (Read 881 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2111
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Husqvarna 45
« on: May 03, 2014, 03:22:13 am »
Quote from: brokenbudget on May 02, 2014, 04:15:33 pm
revive! :-*
noticed the 40/45/49 share most of the parts for the 2040/2045/2050. is there anything that can be done to them like the husky 345/jonny 2145 being able to convert them over to a 346 top end?

You'd have to make a 350/2150 style riser block (to bolt the cylinder to) in order for it to work.
Logged
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.
Pages: [1] 2   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
6 Replies
757 Views 		Last post June 27, 2017, 08:30:17 pm
by Cut4fun .
7 Replies
569 Views 		Last post January 31, 2016, 12:49:24 pm
by 660magnum
0 Replies
139 Views 		Last post March 30, 2016, 07:10:38 pm
by mikehonda
4 Replies
270 Views 		Last post April 12, 2016, 06:30:34 pm
by dannyupsolate
4 Replies
345 Views 		Last post November 07, 2016, 05:46:56 pm
by oldpro
2 Replies
283 Views 		Last post May 15, 2016, 04:59:09 am
by Eccentric
20 Replies
1015 Views 		Last post March 21, 2018, 10:47:30 am
by Cut4fun .
4 Replies
339 Views 		Last post November 23, 2016, 02:23:26 am
by georgehopson
1 Replies
175 Views 		Last post October 26, 2016, 03:40:28 pm
by Eccentric
0 Replies
381 Views 		Last post January 16, 2017, 03:40:49 pm
by HolmenTree