Author Topic: husqvarna 455 rancher  (Read 1286 times)

0 Members and 8 Guests are viewing this topic.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

  • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: husqvarna 455 rancher
« Reply #10 on: April 27, 2014, 11:21:06 am »
I went out and checked the setting on the high and Lo on my 455 this morning.

I am at 6000 ft so I tune a little more lean.   I no longer have limiters I took them off a long time ago.

The high side was just short of 2 turns out.
The Lo side was 1 3/4 turns out.

This saw runs top notch and I have no complaints about it and keeps up with any other saw in the 55cc range.
I run an 18" bar 68dl.
PP 505, 475, 445.

 

Related Topics

  Subject / Started by Replies Last post
46 Replies
8131 Views
Last post July 31, 2011, 09:45:54 am
by farmboy
11 Replies
6366 Views
Last post February 08, 2013, 07:37:59 pm
by Hill Billy
12 Replies
1583 Views
Last post January 14, 2013, 10:18:24 am
by 660magnum
4 Replies
838 Views
Last post May 29, 2018, 07:10:01 am
by Cut4fun .
5 Replies
423 Views
Last post June 09, 2016, 12:43:45 pm
by Cut4fun .
5 Replies
538 Views
Last post November 15, 2016, 08:11:48 pm
by 3000 FPS
1 Replies
389 Views
Last post June 26, 2018, 07:45:18 pm
by Cut4fun .
1 Replies
387 Views
Last post April 01, 2020, 08:41:57 am
by Cut4fun .
2 Replies
432 Views
Last post August 23, 2019, 09:30:07 pm
by ray benson
4 Replies
498 Views
Last post October 01, 2020, 12:40:03 pm
by Spike60