Author Topic: husqvarna 455 rancher  (Read 546 times)

0 Members and 0 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna
Re: husqvarna 455 rancher
« Reply #20 on: April 29, 2014, 11:01:33 am »
Good on ya! At least you found something that may be causing your problem. A guy I once knew always said 'if you didn't find something wrong, you didn't look hard enough'! ::)
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4464
  • Karma: 274
  • Location: Carpenter, Wyoming
Re: husqvarna 455 rancher
« Reply #21 on: April 29, 2014, 11:59:30 am »
The pump lever at the needle valve was the first thing I normally check when rebuilding a carb, this time for whatever reason I Didn't and when I did check it it was way high, to the point it was flooding out. I adjusted it to level but I may need to raise it ever so slightly.I'm going to do that in a bit. I will get back to you on that because I had been thinking of doing it any way . And thanx to all for hanging in there with me. I'll figure it out I always do .



Let us know what you come up with so the rest of us can learn.
PP 505, 475, 445.

 

Related Topics

  Subject / Started by Replies Last post
46 Replies
6044 Views
Last post July 31, 2011, 09:45:54 am
by farmboy
11 Replies
4491 Views
Last post February 08, 2013, 07:37:59 pm
by Hill Billy
12 Replies
783 Views
Last post January 14, 2013, 10:18:24 am
by 660magnum
27 Replies
375 Views
Last post January 22, 2014, 09:23:12 pm
by SawTroll
1 Replies
148 Views
Last post February 21, 2015, 01:44:58 pm
by fuzz1500
4 Replies
372 Views
Last post May 29, 2018, 07:10:01 am
by Cut4fun .
5 Replies
223 Views
Last post November 15, 2016, 08:11:48 pm
by 3000 FPS
1 Replies
105 Views
Last post June 26, 2018, 07:45:18 pm
by Cut4fun .
1 Replies
96 Views
Last post April 01, 2020, 08:41:57 am
by Cut4fun .
2 Replies
146 Views
Last post August 23, 2019, 09:30:07 pm
by ray benson