Author Topic: Husqvarna 455  (Read 2592 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 4120
  • Karma: 171
  • OHIO REDNECK
Re: Husqvarna 455
« Reply #10 on: September 30, 2012, 01:55:17 pm »
It's Running 20" 3/8 oregon vanguard like the new poulan 2050 comes with. 


I just cut  a 16" piece and 20" piece of hard maple with above chain set up. Saw felt smooth and cut as expected for it's cc size. I like this saw for a clamshell design way better then the 290 series by stihl. 

I then cut with the 55 I took in trade  ;) with a afm 46mm open port topend.  I was only running 15" .325 and stihl rsc chain on it.   If they were running same bar and  chain they would be close.    I dont have time to switch them back and forth right now. 

I then ran my 60cc poulan that has a hurt piston in it but still pulling 130psi with new ring and 455 had more toque in the cut then the old  3750 that  and the poulan 365. I guess I should pull out one of the new PP 330 I have.

The 455 was way smoother in the cut then all of the above saws I ran. It just needs a better chain then the vanguard IMO.
REDNECK Saw Repair

 

Related Topics

  Subject / Started by Replies Last post
6 Replies
747 Views
Last post June 27, 2017, 08:30:17 pm
by Cut4fun .
7 Replies
497 Views
Last post January 31, 2016, 12:49:24 pm
by 660magnum
0 Replies
134 Views
Last post March 30, 2016, 07:10:38 pm
by mikehonda
4 Replies
269 Views
Last post April 12, 2016, 06:30:34 pm
by dannyupsolate
4 Replies
344 Views
Last post November 07, 2016, 05:46:56 pm
by oldpro
2 Replies
281 Views
Last post May 15, 2016, 04:59:09 am
by Eccentric
20 Replies
1004 Views
Last post March 21, 2018, 10:47:30 am
by Cut4fun .
4 Replies
339 Views
Last post November 23, 2016, 02:23:26 am
by georgehopson
1 Replies
174 Views
Last post October 26, 2016, 03:40:28 pm
by Eccentric
0 Replies
379 Views
Last post January 16, 2017, 03:40:49 pm
by HolmenTree