« previous next »
Pages: [1]   Go Down

Author Topic: Husqvarna k760 speed problen  (Read 395 times)

0 Members and 0 Guests are viewing this topic.

Offline Vikmata

  • pruner
  • *
  • Posts: 1
  • Karma: 0
Husqvarna k760 speed problen
« on: October 30, 2017, 10:56:39 am »
I have replaces the piston and sparplug but stays the same until time goes by then it warms up and cuts fine but if i run out of gas by the time i start it again is the same thing. 

Can it be a clutch problem?
Logged

Share on Facebook Share on Twitter

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23510
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Husqvarna k760 speed problen
« Reply #1 on: October 30, 2017, 04:24:31 pm »
@3000 FPS has messed with these.
Logged

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4694
  • Karma: 320
  • Location: Carpenter, Wyoming
Re: Husqvarna k760 speed problen
« Reply #2 on: October 30, 2017, 06:53:53 pm »
I would check the belt on it to make sure it is in good shape and has the correct tension.   Then I would check the clutch to make sure it is in good shape.   

If the engine is running ok but the blade has stopped spinning when cutting into concrete or pavers then it is not the carb. 
Logged
PP 505, 475, 445.
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
3 Replies
279 Views 		Last post June 08, 2011, 10:26:25 pm
by mcbob
1 Replies
1381 Views 		Last post November 28, 2011, 11:44:35 am
by bloodontheice
34 Replies
5332 Views 		Last post August 02, 2014, 04:07:59 pm
by 630 red
38 Replies
3139 Views 		Last post February 13, 2019, 01:55:47 pm
by HolmenTree
22 Replies
1093 Views 		Last post April 16, 2016, 07:22:41 am
by jmester
2 Replies
283 Views 		Last post September 15, 2017, 10:04:32 pm
by joe_indi
1 Replies
321 Views 		Last post September 18, 2017, 08:38:44 pm
by 3000 FPS
2 Replies
597 Views 		Last post January 07, 2018, 08:12:37 pm
by jmester
18 Replies
1137 Views 		Last post January 20, 2018, 08:15:54 pm
by mdavlee .
5 Replies
473 Views 		Last post May 05, 2020, 09:30:13 am
by ray benson