Chainsaw Repair

the post by mweba is an excellent answer!....my question is"what good is the dt if it don't tick,but yet the saw runs,restarts good?
and the hook up part on the carb? that's why i'm waiting for the saw to walk back in.

i've had 3 carbs on a 555  with the original original hook up part. 2 of the carbs were the latest available.....i'm waiting on this one also to walk back in. this saw has the running problems kevin just described in his post above.

who is going to be the guy who wants my not working hook ups???....and tears them apart to tell us whats wrong with them and tells us how to fix'em?? 

i've got 3 562's out of the box that pass all the tests,start up good,and are out the door since january & aint been back since (thank god)

i'm still waiting for 545 to sell   

 

I have only had experience with this one 550 but I can tell you the DT tool does not always recognize the processor.  Sometimes I have to plug it back in a couple times.  Not sure if it's a connection issue? Or just a simple read problem.   One thing is for sure, the access to the port is a blessing.

Got just the guy that likes to dig in on the new stuff.   mweba


Mitch there it is. Wasnt you looking for a non-working (whatever you call it in your above video)?

Yes, I want anything Husky does not send a call for.  Very interesting stuff.

So what can you honestly set with this Tool , Husky has for the new autotune saws , can you set anything or just read whats going on in the carb setup , Can you change how the carb setting are bring used, like if you want a richer setting or leaner setting and how much is this tool, I was told the same tool for the 550, 555, 562

should not be that hard to figure out then