Author Topic: Husqvarna T540xp Demo  (Read 7126 times)

0 Members and 42 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2117
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northwestern Wyoming

  • Total Badges: 37
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary
Re: Husqvarna T540xp Demo
« Reply #80 on: November 12, 2014, 03:26:22 pm »
Ran a t540 demo saw at the dealer today and was not impressed. Saw had a weird high high speed miss almost like a rev limiter but it occurred at lower rpm when loaded. Are these autotune carbs? Could be the carburetion wasn't calibrated yet?

Just ran one today too. Not impressed.  Heavier then the 338 and 540 had techlite bar.  Not near the power in the cut of my well broken in 200.  Also felt heavy in the rear 1 handing with 16" techlite.  No where near the balance of the 338 IMO and not as balanced as the 200 was.  All JMO

Wish I would have kept 1 of the 338's before selling them both.

 Glad I bought the used echo now for my uses.

Yes Adam autotune

Kevin which Echo did you get?  CS355T?

 

Related Topics

  Subject / Started by Replies Last post
9 Replies
981 Views
Last post April 09, 2011, 09:18:24 pm
by Cut4fun .
105 Replies
9592 Views
Last post July 15, 2012, 08:40:15 am
by SawTroll
25 Replies
1796 Views
Last post January 01, 2012, 12:13:11 pm
by EHP
2 Replies
647 Views
Last post March 04, 2012, 02:35:58 pm
by Cut4fun .
31 Replies
2078 Views
Last post April 02, 2023, 08:44:02 am
by Cut4fun
1 Replies
407 Views
Last post December 01, 2015, 11:24:23 pm
by Cut4fun .
2 Replies
781 Views
Last post February 21, 2017, 01:22:50 pm
by Cut4fun .
2 Replies
313 Views
Last post May 21, 2018, 04:53:10 pm
by Cut4fun .
5 Replies
838 Views
Last post October 16, 2018, 03:45:23 pm
by Cut4fun .
0 Replies
108 Views
Last post September 15, 2023, 08:42:12 am
by Cut4fun