Author Topic: Husqvarna Tools (Read 776 times)

SawTroll · « **Reply #10 on:** June 30, 2013, 01:37:23 am »

tool list by mweba1, on Flickr

Forget the piston stop and clutch tool- you just knock the clutch off, and none of them are needed!

Also, the 556 is missing in the heading of that list.....

farmboy · « **Reply #11 on:** June 30, 2013, 08:23:32 am »

mweba · « **Reply #12 on:** June 30, 2013, 08:28:01 am »

You will need the crank install tool as well. Bearings are sensitive, early installation procedures at the factory were blamed on failures.

William Greene · « **Reply #13 on:** June 30, 2013, 09:11:04 pm »

i bought 3 piston stops thinking i would need them. i used 1 one time,and it bent taking clutch off

it came out a little dry,and would not go back in

so i went up to a schoolmates shop where he "whipped me up" 2 that work a lot better

jmester · « **Reply #14 on:** November 10, 2013, 11:39:13 am »

If you look in the front of most service manuals they have the special tools list there. At least the couple I have do.

Cut4fun . · « **Reply #15 on:** November 10, 2013, 12:12:03 pm »

Was just sent this husqvarna service tools link to embed here. You need Adobe Reader to open.

[ Guests cannot view attachments ]

660magnum · « **Reply #16 on:** November 10, 2013, 01:59:46 pm »

Yea, that works well

Got it

Chainsaw Repair