Chainsaw Repair

OK, here is the deal on these,

1 we started out with a BB 52mm kit
2 we built a BB 372 using a Hyway kit as the control all else was left stock except we left out the base gasket, had .026 squish.
3 we built a stage 1 saw using a modified 52mm piston in place of the Hyway BB piston.
3(a) we developed a custom set of annealed soft copper gskeets which will allow the end user to set the squish anywhere between .018 and .022 allowing for tolerance between cases and cylinders.
4 we built a dual port muffler on the mufflers made in Brazil for Husqvarna.
5 we changed the carb and intake to that used by a 365/372 X-Torq
6 we then changed the carb to a 390XP carburetor.

Steps 4,5,6 will be optional stage 2,3 and 4.
We did this so that the end user could go as far as their expertise or budget allowed.

We have been testing for over three months by giving test saws out to our customers. Our customers are pro arborists who need saws with consistent performance over time and minimal down time.

These are designed to be work saws that out perform stock saws, not custom one off saws, saws that can be maintained by the owner