Author Topic: New project - 385xp  (Read 1201 times)

0 Members and 0 Guests are viewing this topic.

Offline fatboycowen

  • 4 cube
  • **
  • Posts: 48
  • Karma: 2
  • Location: MA
Re: New project - 385xp
« Reply #20 on: February 07, 2013, 07:22:36 am »
Ah, that makes sense. Which case half should i push the crank into first? 

The bearings that came out of the saw had plastic in them.  I assume if the new ones do, i won't be able to heat them.

It turns out that the front AV mount bolt was simply very loose.  I removed, inspected, then tightened it back into the tank, and it seems firm. 

The AV mount on the cylinder has a rounded out threaded hole on the plastic end. So, i'll replace that one.  The rest of them are fine. 
Jon
Stihl 020T
Husqvarna 345e
Husqvarna 357xp
Husqvarna 562xp
Husqvarna 385xp

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
232 Views
Last post November 15, 2013, 11:01:46 am
by SawTroll
4 Replies
288 Views
Last post November 03, 2015, 02:20:23 pm
by exSW
5 Replies
218 Views
Last post December 25, 2015, 04:05:10 pm
by mdavlee .
1 Replies
70 Views
Last post July 04, 2016, 09:17:17 pm
by Acel83
0 Replies
162 Views
Last post July 05, 2016, 09:31:53 am
by Cut4fun .
2 Replies
309 Views
Last post July 08, 2016, 12:27:43 pm
by Acel83
2 Replies
112 Views
Last post February 28, 2018, 01:24:21 pm
by Cut4fun .
4 Replies
47 Views
Last post January 06, 2020, 12:34:29 pm
by 3000 FPS
4 Replies
177 Views
Last post February 21, 2020, 04:26:07 pm
by Cut4fun .
3 Replies
143 Views
Last post March 11, 2021, 07:13:32 am
by Cut4fun .