Author Topic: New project - 385xp  (Read 1205 times)

0 Members and 0 Guests are viewing this topic.

Offline mdavlee .

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 1968
  • Karma: 171
Re: New project - 385xp
« Reply #20 on: February 07, 2013, 06:18:06 pm »
I heated the halves up in the oven when I did a 390 crank. I put the bearings on the crank first with a socket on the inner race with a 1/2 socket. If I remember right you can use the oil pump as a guide for how far to seat it. I seated that side first and then the starter side. Heat the case halves to around 250 for a half hour or a little longer. You could support the case good and use a large socket to drive the bearing out. I think one side stayed in and the other stayed on the crank when I split the case. My case splitter is almost identical to yours.

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
234 Views
Last post November 15, 2013, 11:01:46 am
by SawTroll
4 Replies
290 Views
Last post November 03, 2015, 02:20:23 pm
by exSW
5 Replies
219 Views
Last post December 25, 2015, 04:05:10 pm
by mdavlee .
1 Replies
72 Views
Last post July 04, 2016, 09:17:17 pm
by Acel83
0 Replies
162 Views
Last post July 05, 2016, 09:31:53 am
by Cut4fun .
2 Replies
311 Views
Last post July 08, 2016, 12:27:43 pm
by Acel83
2 Replies
114 Views
Last post February 28, 2018, 01:24:21 pm
by Cut4fun .
4 Replies
48 Views
Last post January 06, 2020, 12:34:29 pm
by 3000 FPS
4 Replies
177 Views
Last post February 21, 2020, 04:26:07 pm
by Cut4fun .
3 Replies
148 Views
Last post March 11, 2021, 07:13:32 am
by Cut4fun .