« previous next »
Pages: [1]   Go Down

Author Topic: Partner K950  (Read 457 times)

0 Members and 0 Guests are viewing this topic.

Offline deezlfan

  • 5 cube
  • ***
  • Posts: 117
  • Karma: 24
  • Location: Edge of Reality
Re: Partner K950
« on: May 13, 2016, 04:02:45 pm »
There is a good chance that the area of the crank where the threads are is hardened and you may not be able to cut threads with your average consumer quality tap and die set. But the only way to find out is give it a try. You aren't any worse off if you are unsuccessful. You would still have to buy a replacement crankshaft at that point anyway.
Logged
We just drag them down..... Until they're just like us !!!  BNL
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
46 Replies
5730 Views 		Last post November 05, 2021, 06:43:18 pm
by partner
partner 500

Started by man of stihl « 1 2 » Partner

18 Replies
1951 Views 		Last post July 06, 2015, 05:35:27 pm
by aclarke
6 Replies
576 Views 		Last post December 17, 2011, 04:24:09 pm
by brokenbudget
8 Replies
1751 Views 		Last post April 27, 2012, 10:48:06 am
by SawTroll
0 Replies
934 Views 		Last post April 13, 2012, 01:45:51 pm
by man of stihl
7 Replies
1024 Views 		Last post June 09, 2013, 08:34:40 am
by HMLT360Pro
7 Replies
971 Views 		Last post June 04, 2018, 02:01:44 pm
by Cut4fun .
10 Replies
3155 Views 		Last post February 11, 2014, 12:46:47 pm
by Cut4fun .
4 Replies
731 Views 		Last post November 25, 2014, 12:17:42 am
by 3000 FPS
Partner P85

Started by wkend lumberjak « 1 2 3 » Partner

22 Replies
1643 Views 		Last post December 12, 2014, 10:33:16 pm
by awol