Author Topic: Replaced piston/cylinder now won't fire  (Read 2524 times)

0 Members and 63 Guests are viewing this topic.

Offline wbhburn

  • 3 cube
  • *
  • Posts: 24
  • Karma: 0

  • Total Badges: 9
    Badges: (View All)
    One year Anniversary 10 Posts Level 2 Combination Topic Starter First Post
Re: Replaced piston/cylinder now won't fire
« on: October 19, 2013, 02:10:02 pm »
Oh yeah. Please address this question...

the only concern I had when reassembling was the "lump in the throat" of the intake. After putting on the manifold, I felt around inside the joint with my finger and it was smooth and apparently mating well except at the bottom (just above where that little projection on the manifold is supposed to go into the indentation on the port). It was raised slightly there. Could that be the problem? There is a small orifice on that protrusion that connects with the little tube thing. Could that not being seated properly cause the problem?

 

Related Topics

  Subject / Started by Replies Last post
2 Replies
629 Views
Last post August 04, 2011, 08:04:28 pm
by Old Iron Logging
28 Replies
2530 Views
Last post February 16, 2012, 06:58:36 am
by brokenbudget
12 Replies
1201 Views
Last post January 26, 2012, 09:09:40 am
by ECpirates96
0 Replies
473 Views
Last post May 24, 2012, 08:20:22 pm
by MP5N
20 Replies
3673 Views
Last post March 18, 2022, 07:56:44 am
by Cut4fun .
19 Replies
1406 Views
Last post September 09, 2013, 09:51:10 pm
by doreadeal
40 Replies
2334 Views
Last post December 20, 2013, 01:00:22 pm
by Spike60
17 Replies
1490 Views
Last post May 12, 2014, 12:40:25 am
by sharkey
21 Replies
1841 Views
Last post November 29, 2014, 08:29:17 am
by weimedog
1 Replies
263 Views
Last post October 27, 2023, 10:20:52 am
by Cut4fun .