Author Topic: Replaced piston/cylinder now won't fire  (Read 1766 times)

0 Members and 0 Guests are viewing this topic.

Offline sharkey

  • Piped Saw
  • *****
  • Posts: 367
  • Karma: 37
Re: Replaced piston/cylinder now won't fire
« Reply #20 on: October 21, 2013, 12:40:25 am »
So I'll need to remove the handle/tank to get to the crank seams right? 
The crank seals are behind the clutch and behind the flywheel.  Use a piece of rope down through the spark plug hole to lock down the crank so you can turn the nuts.  Remove the clutch by reverse thread meaning it turns clockwise to loosen.  On the flywheel side, loosen the flywheel nut but dont take it all the way off the crank.  Use a soft hammer and tap the nut at the top of the crank threads (to protect them) and off pops the flywheel.         

 

Related Topics

  Subject / Started by Replies Last post
2 Replies
518 Views
Last post August 04, 2011, 08:04:28 pm
by Old Iron Logging
28 Replies
2166 Views
Last post February 16, 2012, 06:58:36 am
by brokenbudget
12 Replies
936 Views
Last post January 26, 2012, 09:09:40 am
by ECpirates96
0 Replies
322 Views
Last post May 24, 2012, 08:20:22 pm
by MP5N
20 Replies
3194 Views
Last post March 18, 2022, 07:56:44 am
by Cut4fun .
63 Replies
3145 Views
Last post October 26, 2013, 05:32:17 pm
by davbell22602
19 Replies
980 Views
Last post September 09, 2013, 09:51:10 pm
by doreadeal
40 Replies
1549 Views
Last post December 20, 2013, 01:00:22 pm
by Spike60
17 Replies
801 Views
Last post May 12, 2014, 12:40:25 am
by sharkey
21 Replies
1171 Views
Last post November 29, 2014, 08:29:17 am
by weimedog