Author Topic: Small 40cc saw with metal dawg husqvarna 435 ?  (Read 321 times)

0 Members and 0 Guests are viewing this topic.

Offline 660magnum

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 6437
  • Karma: 249
  • For The Love Of Chainsaws
  • Location: NCO
Re: Small 40cc saw with metal dawg husqvarna 435 ?
« on: January 08, 2014, 05:29:35 pm »
Don't forget the screws to hold the dawg on?

That 435 had NK chain/bar.

Had to tune it a couple more times for his fuel mix was different and then had to tune it again when the weather got cold but no problem, I have the magic screw (splined) driver I got from HL Supply..

It is a strato. Runs good in the wood. Can not imagine what EPA was thinking with the splined screws? I suppose he could take it to the Husqvarna dealer and get it back two months later after they adjust the high needle? Certainly cannot get it adjusted at the big box store where his son bought it.
We should share what we know... someone may learn...
That knowledge can live after us... and that "Pays It Forward".
Be all that you can be . . .

 

Related Topics

  Subject / Started by Replies Last post
0 Replies
420 Views
Last post January 05, 2012, 07:24:56 pm
by Cut4fun .
10 Replies
1093 Views
Last post August 22, 2012, 06:55:02 pm
by Al Smith
9 Replies
300 Views
Last post May 12, 2014, 01:11:19 pm
by brokenbudget
0 Replies
206 Views
Last post October 11, 2014, 11:06:11 pm
by jvd850
18 Replies
507 Views
Last post December 17, 2014, 10:47:07 am
by srcarr52
3 Replies
349 Views
Last post August 21, 2015, 12:53:25 pm
by Cut4fun .
14 Replies
268 Views
Last post March 29, 2015, 01:51:20 pm
by Cut4fun .
19 Replies
658 Views
Last post December 29, 2015, 01:03:50 pm
by 3000 FPS
1 Replies
152 Views
Last post September 18, 2017, 08:38:44 pm
by 3000 FPS
1 Replies
124 Views
Last post February 03, 2018, 07:42:16 am
by Cut4fun .