Author Topic: husqvarna 372 x torq??  (Read 2476 times)

0 Members and 0 Guests are viewing this topic.

Offline blsnelling

  • 4 cube
  • **
  • Posts: 58
  • Karma: 7
Re: husqvarna 372 x torq??
« Reply #10 on: May 03, 2011, 09:49:54 pm »
The new 372XP X-Torq is definately stratofied.  However, they built the saw off the same crankcase as the 372 we have always had.  It does use a single venturi to feed both the clean air and the fuel charged air.  The carb has a divider in it so that only one half of it takes on fuel.  This divider continues through the intake duct and into the cylinder.  I have not modified a 575, so can't really tell you how it compares.  Hope that helps a little.

 

Related Topics

  Subject / Started by Replies Last post
127 Replies
13068 Views
Last post December 26, 2012, 10:16:57 am
by Cut4fun
2 Replies
578 Views
Last post July 23, 2012, 07:49:15 am
by 660magnum
9 Replies
918 Views
Last post November 17, 2012, 09:05:18 pm
by Mw1995
19 Replies
781 Views
Last post November 10, 2013, 08:11:53 pm
by KilliansRedLeo
6 Replies
311 Views
Last post June 09, 2014, 08:05:24 pm
by Cut4fun .
8 Replies
166 Views
Last post September 25, 2014, 08:38:08 pm
by aclarke
7 Replies
214 Views
Last post February 28, 2016, 07:32:00 pm
by 660magnum
2 Replies
187 Views
Last post August 22, 2016, 01:46:46 pm
by dannyupsolate
2 Replies
100 Views
Last post May 07, 2018, 02:36:08 pm
by Cut4fun .
4 Replies
137 Views
Last post July 12, 2018, 09:03:40 am
by ray benson