Author Topic: Unlimited coil for 372xp timing?  (Read 2512 times)

0 Members and 8 Guests are viewing this topic.

Offline eriksat1

  • 4 cube
  • **
  • Posts: 51
  • Karma: 4

  • Total Badges: 11
    Badges: (View All)
    Level 3 One year Anniversary 10 Posts Combination Topic Starter Level 2
Re: Unlimited coil for 372xp timing?
« Reply #10 on: February 13, 2014, 12:31:08 pm »
That is why I am going to check the timing before I take the oem one off, just mark it with a permenant marker at low and high rpm. and see where the new coil is at. In the video it was about right in the middle and didn't change with rpm. Hard to say if you could notice the difference in 2 or 3 degrees either way? You would need a dyno or someone timing your cuts with a stop watch.

 

Related Topics

  Subject / Started by Replies Last post
0 Replies
338 Views
Last post August 11, 2011, 04:07:35 pm
by Roanoker494
8 Replies
1252 Views
Last post May 12, 2012, 09:30:03 pm
by Al Smith
timing

Started by jmester « 1 2 3 » Stihl

20 Replies
1875 Views
Last post January 17, 2013, 09:06:02 pm
by 660magnum
100 Replies
5997 Views
Last post February 24, 2013, 12:54:05 pm
by jmester
12 Replies
3746 Views
Last post March 27, 2016, 01:48:26 pm
by gregh
6 Replies
566 Views
Last post November 02, 2015, 07:43:33 pm
by Al Smith
26 Replies
2984 Views
Last post May 16, 2016, 09:03:07 pm
by Cut4fun .
2 Replies
1793 Views
Last post March 20, 2016, 01:15:19 pm
by 660magnum
5 Replies
510 Views
Last post July 20, 2016, 07:33:47 pm
by 1manband
16 Replies
1841 Views
Last post May 06, 2017, 10:33:19 am
by Cut4fun .