« previous next »
Pages: 1 2 [3] 4 5   Go Down

Author Topic: Who makes good cylinder, piston rings, for 372 and 390xp's?  (Read 2385 times)

0 Members and 57 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna

    • Total Badges: 29
    Badges: (View All)
    2000 post CR Staff One year Anniversary 1000 Posts Never Sleep Group
Re: Who makes good cylinder, piston rings, for 372 and 390xp's?
« Reply #20 on: November 23, 2013, 09:58:58 pm »
Well, your a bigger guy than I am, I have the same saw and I can start it without problem. 200psi is a lot, but it only takes a couple of short pulls to get mine going! Check your timing.
Logged
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826
Pages: 1 2 [3] 4 5   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
30 Replies
3058 Views 		Last post October 09, 2015, 06:45:45 pm
by Cut4fun .
7 Replies
1461 Views 		Last post October 20, 2021, 01:25:56 pm
by 3000 FPS
0 Replies
475 Views 		Last post May 24, 2012, 08:20:22 pm
by MP5N
19 Replies
1415 Views 		Last post September 09, 2013, 09:51:10 pm
by doreadeal
3 Replies
1025 Views 		Last post November 06, 2013, 05:35:04 pm
by Captain Howdy
4 Replies
454 Views 		Last post February 02, 2014, 07:51:15 am
by fossil
1 Replies
562 Views 		Last post March 09, 2014, 03:41:36 pm
by stihls066
8 Replies
852 Views 		Last post March 17, 2014, 09:07:10 am
by fordfairlane78
2 Replies
311 Views 		Last post February 24, 2016, 09:44:04 pm
by 604f_1
0 Replies
266 Views 		Last post May 15, 2016, 04:28:51 am
by Eccentric