« previous next »
Pages: 1 2 [3] 4 5   Go Down

Author Topic: Who makes good cylinder, piston rings, for 372 and 390xp's?  (Read 2386 times)

0 Members and 44 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna

    • Total Badges: 29
    Badges: (View All)
    2000 post CR Staff One year Anniversary 1000 Posts Never Sleep Group
Re: Who makes good cylinder, piston rings, for 372 and 390xp's?
« Reply #20 on: November 23, 2013, 10:10:16 pm »
Grit your teeth and get the saw running, get it to idle, then let it run until it runs out of gas. After that it should be easier to start.

Nobody ever said that a high performance saw was going to be a 'home owner' cake walk saw to start.
Logged
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826
Pages: 1 2 [3] 4 5   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
30 Replies
3058 Views 		Last post October 09, 2015, 06:45:45 pm
by Cut4fun .
7 Replies
1461 Views 		Last post October 20, 2021, 01:25:56 pm
by 3000 FPS
0 Replies
475 Views 		Last post May 24, 2012, 08:20:22 pm
by MP5N
19 Replies
1415 Views 		Last post September 09, 2013, 09:51:10 pm
by doreadeal
3 Replies
1026 Views 		Last post November 06, 2013, 05:35:04 pm
by Captain Howdy
4 Replies
454 Views 		Last post February 02, 2014, 07:51:15 am
by fossil
1 Replies
562 Views 		Last post March 09, 2014, 03:41:36 pm
by stihls066
8 Replies
852 Views 		Last post March 17, 2014, 09:07:10 am
by fordfairlane78
2 Replies
311 Views 		Last post February 24, 2016, 09:44:04 pm
by 604f_1
0 Replies
266 Views 		Last post May 15, 2016, 04:28:51 am
by Eccentric