Chainsaw Repair
Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Partner => Topic started by: Modifiedmark on March 20, 2011, 11:34:54 am
-
Here is my 7000+, just showing it off, and seeing if I can figure out posting pictures.
-
very nice :)
-
Does the 7000 have a WJ governed carb too?
Mark it's actually easier to have a free photobucket account for posting pic's here. Then they can be as big as you like.
After getting close to finishing the first 550, I think I'm going to pass on my idea of putting a P70 or 7000 top end on one. Unless a top end falls in my lap.
-
Here is my 7000+, just showing it off, and seeing if I can figure out posting pictures.
Looks really nice! ;D
-
Does the 7000 have a WJ governed carb too?
Mark it's actually easier to have a free photobucket account for posting pic's here. Then they can be as big as you like.
After getting close to finishing the first 550, I think I'm going to pass on my idea of putting a P70 or 7000 top end on one. Unless a top end falls in my lap.
Kevin, I would have to look, I don't remember, but I think so.
-
Do you have any video of the 7000+ in the cut? ;D ;D
-
One of the guys I use to race with has a new 7000 + for sale but in my mind he wants to much for it , if he lowers his price I will post it for some one to buy it , I found the saw at a old timer saw shop and bought it for $150 then sold it to Hugh for the same price as I knew he was looking for one , I also got him a P100 and a couple 5000+. The 7000 and the P100 never had gas in them
-
Please do let us know of the saws for sale!
-
he has them for sale but is dreaming on the price HUGE , they will never sell so hopefully he comes to his sense's and puts a descent price ok them
-
Please do let us know of the saws for sale!
Believe me Mark I already checked on it when first posted :D. It's all yours.
-
OK, I got cha! I aint made of money either. ;D
-
Do not worry , if he comes up with a fair price I will let you know , I sold these saws to him about 12 to 15 years ago for $150 a piece cause he wanted them for his collection , now he wants 4 times that amount
-
Did some saw swapping and picked this Up.
-
Dang clean one. Must have just been a homeowner type cutter owned.
-
I don't think it ever has cut more than half a tank.
-
Yep that is sure a pretty saw. Very nice.
-
I was checking that NOS partner cylinder for a guy. Turns out it is a 50mm closed port. Should fit the 55 65 70 7000. Also a NOS piston kit.
My P65 was 48mm and P55 was 44mm. P70 700 7000 50mm
-
As of now 50mm p+c spoke for.