Chainsaw Repair
Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Stihl => Topic started by: northern boy on January 06, 2014, 02:40:57 pm
-
hey guys new to the form looks like a great site need some help just got a ms310 used put half a dozen cuts on it and it ran alittle fun so took it to the local shop to get get it tuned up and the piston and cylinder r shot should I replace the bearings and oil seals well doing the job i'm up in Canada not sure where to get parts any advice will be great thanks ???
-
Put a 390 engine unit in it? The same one fits the 290, 310, and 390.
-
k ill look in it thanks 660
-
the carbs are the same on all those.
I don't know a good Canadian source but Ebay is full of after market engine units. They seem to hold up pretty well.
-
will the carb set up be the same as the 310
???
-
yes
-
Here is what 660 is talking about I think. http://www.baileysonline.com/Chainsaws/Chainsaw-Parts/Short-Blocks/Shindaiwa/NWP-49mm-Short-Block-Cylinder-for-Stihl-Chainsaws-029-039-MS290-MS310-MS390.axd
Suppose to be bolt in ready to go.
Click on stihl board and look down a few threads where someone used one on a 290 build to 390.
-
k once again thanks ill take a look how much should it cost don't want to get screwed
-
posted above your last post.