Chainsaw Repair
Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Jonsered => Topic started by: John Mc on June 11, 2011, 07:33:35 am
-
I've got a Jonsered 2152 that leaks bar oil, and has since just about the day I bought it. This is not just oil dripping out from retained wood chips around the clutch area... I get a puddle under the saw even if I clean it off after using it. The dealer says that "some of these saws just do that" - I have a hard time believing this can't be fixed. He also suggested I try loosening the oil cap so pressure doesn't build up due to temperature changes when I store it... that did not stop the problem.
Any ideas on where I should start to look?
John Mc
-
I no nothing about a 2152. My WAG though. I have seen a 346 and 372 leak from get go and it was from stripped out hole pump bolt on one and the o-ring mating surface from oil pump to crankcase on other.
2152 IPL page 2 shows oil pump and hoses http://s30387.gridserver.com/partsDiagrams/Jonsered%202152.pdf
-
Probably the oil pump hose not sealing where it passes through the tank. If so, it would need to be replaced.