Chainsaw Repair

Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Poulan => Topic started by: Jason K on July 29, 2014, 11:57:01 pm

Title: PP5020 RPM Settings Needed
Post by: Jason K on July 29, 2014, 11:57:01 pm

I got a PP5020 in too set the rpms. I would like to know the settings.

Thanks
Jason

Title: Re: PP5020 RPM Settings Needed
Post by: Cut4fun . on July 30, 2014, 09:54:10 am

13K  I liked mine around 12.8K

When I got mine new.
I checked factory settings and then put them back to see. L was 1.5 and H was 2 - 2.5 out (sorry cant remember H off hand).

It would start and not idle and shut off. Start and bog giving throttle.

I kept adjusting the carb till I ended up with about 3 out on L and left 2-2.5 on H at about 12.8K. Turned the I idle up too.  Not like the 1 to 1.5 turns out we get used to.

Thread on poulan 5020. http://chainsawrepair.createaforum.com/poulan/poulan-pro-5020/

Title: Re: PP5020 RPM Settings Needed
Post by: Jason K on July 30, 2014, 09:10:59 pm

Thanks for the info.

Jason

Title: Re: PP5020 RPM Settings Needed
Post by: 3000 FPS on July 31, 2014, 01:06:25 am

13K, that is not bad.   I did not know they tuned that high of RPM.