Chainsaw Repair

Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Dolmar Makita => Topic started by: pigpen60 on August 03, 2014, 05:17:33 pm

Title: ps-9010
Post by: pigpen60 on August 03, 2014, 05:17:33 pm
is the ps-9010 sold here in the us?
Title: Re: ps-9010
Post by: Nathaniel Vansickle on August 03, 2014, 05:29:16 pm
nope. pulled from the market a few years ago. EPA said it was to dirty
Title: Re: ps-9010
Post by: pigpen60 on August 03, 2014, 07:09:57 pm
not that I needed it but dang! 90cc's!
Title: Re: ps-9010
Post by: farmboy on August 03, 2014, 08:09:09 pm
The ones I've seen on Ebay brought more than they cost when they were available.  9010 is on my list.  IIRC there isone on there now.  Didn't bother to watch it.
Shep
Title: Re: ps-9010
Post by: KilliansRedLeo on August 03, 2014, 08:27:04 pm
I have the Solo version of the 9000, Solo 694, it is a beast!
Title: Re: ps-9010
Post by: srcarr52 on August 04, 2014, 10:09:03 am
This one is a beast.

https://www.youtube.com/watch?v=Da5BPZKcryo
Title: Re: ps-9010
Post by: Nathaniel Vansickle on August 04, 2014, 10:22:15 am
I have been thinking about building one from new parts but there is another project I just haven't found time to do along with the fact it would easily run $1000 at cost.
Title: Re: ps-9010
Post by: pigpen60 on August 04, 2014, 01:25:31 pm
you couldn't buy one overseas and have it shipped here?
Title: Re: ps-9010
Post by: pigpen60 on August 04, 2014, 01:29:17 pm
in the video with the Makita, I heard that crackly pop sound when he revved it up to start the cut. is that " 4 stroken" due to a rich condition? it smoothed out in the cut so I figure that was it.
Title: Re: ps-9010
Post by: Cut4fun . on August 04, 2014, 01:54:06 pm
I seen the makita versions selling dirt cheap just a few years ago. Seen ported going for $500 like new, stock $400.   Talking look new saws.
Title: Re: ps-9010
Post by: srcarr52 on August 04, 2014, 03:01:54 pm
in the video with the Makita, I heard that crackly pop sound when he revved it up to start the cut. is that " 4 stroken" due to a rich condition? it smoothed out in the cut so I figure that was it.

It's wildly ported and it likes its fuel.  They also have a rev limited coil at 13-13.5k.  So out of the cut they sound like a Tasmanian devil trying to get out of them. 

Still, it takes a lot of load to get it to fully clean up, you'll still hear a pop or two in the cut.  Makes you defecate yourself when you first hear it but that is tuned to where it's making happy power.  Nathan is pretty happy with it, I'm porting a second one for him.
Title: Re: ps-9010
Post by: pigpen60 on August 04, 2014, 03:57:58 pm
I don't know anything about tuning but im trying to pick up on it.